NIBBI Racing Parts Replacement High Performance GY6 Intake Manifold Intake Manifold Boot for GY6 Engine Scooter 125CC 150CC

Worked flawless on a 139qmb 50cc short case engine. I put a big bore kit on to 72cc but kept stock head. At first I rigged a 5 hp Briggs carb onto the engine using this intake and it didn’t start easy(no choke on the carb I used) but once it did, it ran way better then Expected. I made the up grade to a nibbi carb I believe the 24mm one and after swapping around the included jets iv gone from 23.4 mph to 34.3 average( remember from Briggs carb). I highly recommend going with the full nibbi line up of throttles, cable, carb, and intake. I found a k&n air filter for $24 that fit perfect on here also. It’s impressed everyone who’s rode it and iv put well over 1000 miles on with the bore kit and nibbi intake system. The only thing that changed was the the location of the nipple that the vacuum from the head attaches switched sides and I had to remove the little plastic cover over the timing chain tensioner is all. But it shorten and cleaned up the look on my bike. Great solid products from nibbi and also I received some packages in less then 24 hours with prime. But they did get shipped from only one state over. All packages were received in less then 48 hours from them

This won't work in every application. I had to machine adapters to make it work in my application on a Chinese 150 scooter.

Looks well made and good quality material and machine work besides a little bur I scrapped out my fingernail

GOOG quality part. Not for taotao. Right mounting carb.

En una venton 150cc con un oko 32 e85

Overall, I like the feel and the quality of the materials. The Good: The stainless steel hose clamps feel good and work smoothly. The silicone coupling feels fantastic and has internal sealing ridges, to make sure that you have a nice tight seal once tightened down to the carb. The aluminum bulk of the body feels good and the brass Barb seems pretty standard from the plumbing section of the hardware store. The machining of the holes to mount this to the motor has some some rough edges, but will work as-is. The Cons: The groove for the O-ring to seal against the motor is not at an even depth and will cause problems down the road. Pictures will show that one side allows the o-ring to sit at a proper depth, while the other side would crush the o-ring and mean that you will get leaks and have to replace each time that it is removed. Pictured...poorly: Inside the turn of the aluminum 45deg elbow, there is relatively large lip that will need to get ground down and sanded smooth. If the step of the lip faced the other direction it would have less impact on the flow of air. Overall it is a good piece with good materials to start with, but will take some elbow grease, tools, and some attention to detail to make the most of it.

It's a great part for maximum airflow, I even installed on my 50cc JMSTAR SHENKE GY6 50cc scooter and it fit like a glove and now it's running great!!! Would highly recommend this piece of you're changing out the carb like I did

nice for the price

キャブレターの水平角度が取れて助かりました。商品の造りも、大変良く出来ていました。